ABS 3D printing for tough, heat-resistant parts
The engineering plastic behind many moulded products. Choose ABS for enclosures, housings and parts that run warm.
Note 1. Typical filament values. Your part depends on design and settings.
Why choose ABS
- 1.Tough and impact resistant, so parts take knocks without cracking
- 2.Higher heat resistance than PLA and PETG, softening at around 100°C compared with about 60°C for PLA and 88°C for PETG
- 3.The same plastic family as many injection-moulded products, useful for prototypes that should behave like production parts
- 4.Takes drilling, tapping, sanding and painting well after printing
- 5.A good fit for electronics enclosures and housings near motors or other warm components
What teams print in ABS
- 01Electronics enclosures
- 02Product housings
- 03Automotive interior parts
- 04Functional prototypes
- 05Jigs and fixtures
- 06Tool handles and clips
Is ABS the right choice?
- AChoose ABS when
- Your part needs toughness and heat resistance indoors, such as an enclosure, housing or fixture near warm equipment.
- BChoose ASA instead
- If the part lives outdoors or in sunlight. ASA has similar strength and heat resistance to ABS but resists UV yellowing and weathering.
- CChoose PETG instead
- If heat is moderate and you want an easier, lower-cost functional material with good toughness and moisture tolerance.
Comparing materials for a functional part? Read our guide to choosing a material for functional parts.
ABS printing questions
Is ABS stronger than PLA?
ABS is tougher than PLA: it bends and absorbs impact rather than snapping. PLA is stiffer and easier to print, but softens at a much lower temperature.
ABS or PETG for a functional part?
Choose ABS when the part runs warm or needs to behave like a moulded plastic part. Choose PETG for general functional parts where heat is moderate and cost matters.
Can ABS be used outdoors?
ABS degrades in sunlight over time. For outdoor or sun-exposed parts, ASA is the better choice because it has similar properties with much better UV resistance.
Can you print large ABS parts?
Parts fit within our 256 x 256 x 256 mm build volume, but large flat ABS parts are prone to warping. Send your file and we will advise on orientation, splitting or a better material.
Ready to print in ABS?
Upload your STL for an instant price. We review every file, and suggest another material if it suits the part better.